DOSAGE AND METHOD OF USE:

* Initial treatment: Add 10 - 15 g of DICLORO for every m3 of water. After 2 hours, adjust the pH of the water between 7.2 and 7.6 using PH PLUS and PH MINUS.

* Maintenance Treatment: With the correct water pH, add 1 to 3g of GRANULAR CHLORINE per m3 of water daily.

These dosages are of an orientational nature and can be modified according to the characteristics of each swimming pool, climatology, etc.

The Initial Treatment (Super Chlorination) must be repeated whenever there is a lack of water transparency.

Introduce the required dose of GRANULAR CHLORINE inside a skimmer, then put the filtration system into operation so that the product can be dissolved by the circulation of the water through the skimmer.

The dose of granular Chlorine can also be spread evenly over the surface of the pool.

The free residual chlorine must be located between 0.5 and 1.5 mg / l, a value that can be easily measured using a special chlorine and pH analyzer.

This check should be carried out at least twice a day.

The information contained in this technical sheet is correct on the basis of our knowledge, nevertheless, since the conditions in which this product is used are not under our direct control, we assume no responsibility for any damage resulting from its incorrect use.